- The ‘GDS Drive Bolt’ has been manufactured primarily to use as effective locking for dual swing gates
- The GDS Drive Bolt is mounted to the end of a swing gate and is wired into the controls to lock the gates to the ground
- The Drive Bolt Slim is designed for smaller gate frames, <50mm wide, they can have a 50mm, 130mm or 200mm travel length
- Upon command to open the gate, the control board provides 24v power to the ‘drive Bolt’ to retract the pin; 3-4 seconds later the gates can swing open
- The ‘GDS DB’ model can lock the gates in the fully open and closed positions. Should there be a power failure the GDS DB can be manually released via a key on the cover
- The GDS DB Entry and GDS DB Slim will lock the gates in the closed position. Should there be a power failure they can be manually released by removing the cover and pulling on the release cable